CivilFEM Online Help

~PLLSCON

 

~PLLSCON, Lab1, FACT

Plots concrete beam checking and design results in concrete beams

POST1: Concrete Checking

Lab1

Label identifying the result to be drawn. Results depend on active code and checking being made.

FACT

Scale factor.

Notes

- Apart from the results specified for each check, the label Lab1 = ELM_OK can be used to Plot the elements that fulfil (green) or not (red) the code for the selected check.

- For more information about the content of the element results look up in the Theory Manual in each of the chapters related to the codes, or the help for the ~CHKCON and ~DIMCON commands.

- The graphic output will be saved in two temporal element tables named CFETAB_I and CFETAB_J.

- The annotations that appear in the graph are automatically deleted in order to avoid being shown in the following drawings. Therefore, if the command “Replot” is used, the new drawing will not have annotations. To get back the annotations, issue the ~PLLSCON command again or send it to a file.

- All design is made according to the specifications of the code corresponding to the type of design requested, following the procedures described in the Theory Manual.

- To access the command through the menu option, the corresponding concrete code must be active. (See ~CODESEL command).

Menus Path

Main Menu > CIVIL Postprocessor > Code Checking > ###### > BEAM RESULTS: Plot Results

Where ###### represents the active code (reinforced concrete).

¾¾¾¾¾¾¨¾¾¾¾¾¾