CivilFEM Online Help

~SLPCIR

 

~SLPCIR, X0, Y0, X1, Y1, X2, Y2, N1, N2

Introduction of points defining the circle mesh (by coordinates)

PREP7: GEOTECHNICAL MODULE: Slope stability

X0

X coordinate, of the “main” vertex of the parallelogram.

Y0

Y coordinate, of the “main” vertex of the parallelogram.

X1

X coordinate, of vertex 1 of the parallelogram.

Y1

Y coordinate, of vertex 1 of the parallelogram.

X2

X coordinate, of vertex 2 of the parallelogram.

Y2

Y coordinate, of vertex 2 of the parallelogram.

N1

Number of centres of the side from point 0 to point 1.

N2

Number of centres of the side from point 0 to point 2.

Notes

- If N1 or N2 equals 1 (it cannot be 0), centres are generated in the side defined by ends (for instance, if N1=2 and N2=1, two centres are generated in (X0,Y0) and (X1,Y1)) Even in these cases, it is necessary to define the parallelogram not degenerated.

 

- The coordinates are defined in the active CSYS when ~SLPIN was launched or the KCN introduced in this command.

Menu Paths

Main Menu > Civil Preprocessor > Geotech. Mod. > Slope stability > Define > Graphical Input

¾¾¾¾¾¾¨¾¾¾¾¾¾